Default Routes Lab

You have the job to setup a small customer network. Host A (on the left) should be setup with an IP address of 192.168.101.2 /24 and a default gateway of 192.168.101.1. Host B (on the right) should be setup with an IP address of 192.168.100.2 /24 and a default gateway of 192.168.100.1. The Ethernet interface of Router1 (on the left) should use an IP address of 192.168.101.1 /24 and the Serial interface of Router1 should use an IP address of 192.168.1.1 /24. The Ethernet interface of Router2 (on the right) should use an IP address of 192.168.100.1 /24 and the Serial interface of Router2 should use an IP address of 192.168.1.2 /24. You have a DCE cable connected to Router1. The serial link should have speed of 64K. Configure the routers with default routes so that all devices can ping any other device.

default Routers

R1:
hostname router1
!
interface Ethernet0
ip address 192.168.101.1 255.255.255.0
no shut
!
interface Serial0
ip address 192.168.1.1 255.255.255.0
clock rate 64000
no shut
!
ip route 0.0.0.0 0.0.0.0 192.168.1.2
R2:
hostname router2
!
interface Ethernet0
ip address 192.168.100.1 255.255.255.0
no shut
!
interface Serial0
ip address 192.168.1.2 255.255.255.0
no shut
!
ip route 0.0.0.0 0.0.0.0 192.168.1.1
Host A:
Ipconfig /IP 192.168.101.2 255.255.255.0
Ipconfig /DG 192.168.101.1
Host B:
Ipconfig /IP 192.168.100.2 255.255.255.0
Ipconfig /DG 192.168.100.1

Back

Copyright ┬ę2010 - ┬á2018 Ciscoforall.com | Privacy Policy