Showing 10 of 522 Blog Posts
RIP (routing information protocol) configuration forRIP v1 and RIP v2 Router# conf terminal Router(config)# int e0 Router(config_if)# ip add 192.168.10.10 255.255.255.0 Router(config_if)# no shut Router(config_if)# exit...
When we want to access a system or network which is laying on router 3. so we will access it statically as Router# conf terminal...
In Static routing the network administrator hand type the path for routing. As Router>enable Router# conf terminal Roter(config)# int e0 Router(config_if)# ip add 192.168.10.10 255.255.255.0 Router(config_ig)#...
It is used to select the destination path automatically. Router > Router >enable Router(config)# conf t Router(config)# int e0 (or fa 0/0 it change with...
Port security is used to secure the port of a layer 3 switch for the purpose of to not access that port except the dedicated mac address...
By default only hosts are member of the same VLAN can communicate. To change this and allow inter-vlan communication, we need a layer 3 switch or router....
Attenuation Line attenuation is in relation to the “loop loss” on your line. The lower this figure the better, and the better chance you have of getting...
It consistent VLAN configuration across all switches in the network.VLAN trunking over mixed networks, suck as Ethernet ATM LAN or even FDDI. It accurate tracking and monitoring...
Create VLANs on a Cisco switch, assign access ports, configure trunks and verify the configuration with current IOS commands.
Your purchase with Ciscoforall is safe and fast.
Your Learning Solution will be available for immediate download after your payment has been received.
 |  |